Create Your Own Coke

First you copy and paste the picture with the pop tops into the picture with the blank can. Then use the move tool to position the pull tabs as accurately as possible to the can. Reduce the opacity to 60%, and erase the excess pull tab around the outside of the can. Make a new file for the label about 5 by 2.5 in and 72ppi. Then use the type tool and put TaBs in tomhama font 200 point size. Reduce the B and s by making them 170 point size. Now use layer, simplify layer. Tighten up the letter spacing by making a rectangle selection around the a, then switch to the move tool, use the left arrow key to move it closer to the T, repeat for the B and s. Extend the top of the T by make a rectangular selection of the crossbar and use the move tool while holding down shift/alt and drag it (the crossbar) to the right. After that make a rectangular selection on the upper curve of the a and paint the area black. Use the white paint brush to get rid of the excess black. Repeat for the s. Then use the erase tool to eliminate the black connecting the a and the b(see the finished label). Curve the logo around the can by copy and pasting it into the can picture. Flip the background image 90 degrees left and then click on the label layer and go to filter, distort, shear, adjust the can by clicking on the center of the curve and dragging it right. Then you can flip your can upright. Change the background of the can using the magic wand tool to select the can and then inverse, and use the gradient tool on the background.